Wednesday, 31 May 2017

Pinspired - Stable Door birthday card

There's probably a more correct name for this - but to me it's a stable door!  The original Pin is here.



Quite tricky to photograph so the full effect can be seen!
I cut an A4 piece of cardstock in half lengthwise, scored at the centre and then carefully cut the top half of the card front off.  Then I used some paper from a 6" pad for the inside and the front, being careful to line up the design so both panels matched.
The flowers are from SU, stamped and punched out.  The card actually sat in my 'to be finished' box for a while, because I couldn't find a stamp which felt right for the sentiment.  Obviously I don't have enough sentiments, after 24 years of stamping....... Hah!!!  Then I was having a bit of a sort out and came across this Woodware one, there are two big stamps in the set and this one looked best. It's now permanently in the stamp bags which comes to every crop with me - can't believe I had forgotten about it!
I really like this, it's a little different and I think it could be adapted quite easily to masculine cards - I'm sure I have just a few cogs and gears stamps just lying around...... LOL.

No comments:

Post a Comment